Blue Traxx Forum banner

Who will win?

  • Factory Effex

    Votes: 0 0.0%
  • Yamaster

    Votes: 0 0.0%
Status
Not open for further replies.
1 - 20 of 34 Posts

·
Registered
Joined
·
2,635 Posts
Discussion Starter #1
Which one in a drag race? Me on my Cr125 or Yamaster on his blaster?

His mods are...
2003 mx blaster
sum of the mods
elaka's
cp customs mx port job and head mod
toomey pipe combo
razrs mx
holeshots mx
douglas 190s
the list goes on

and Mine are...
 

·
Registered
Joined
·
124 Posts
the rest of my mods are boysen carbon fibre reeds, cp customs top end mx porting set up to run 95 octane, 18 inch rear razrs mx, 19 inch holeshots up front all on douglas 190s, bored out intake boot, toomey twin air filter, no air box lid, wisco piston, bored .030 over stock,lots of unneded parts removed, and sum more
 

·
Registered
Joined
·
124 Posts
heres a few pictures of my quad :tup:



 

·
Registered
Joined
·
2,635 Posts
Discussion Starter #7
If your going to run 18's then I would really F'n Murder you :lmao:
 

·
Registered
Joined
·
5,541 Posts
That Blaster could be really fast, but I would put my money on the CR. Its a really close race between 125's and me on my mildly modded Z400.
 

·
Registered
Joined
·
3,937 Posts
mxthunder said:
That Blaster could be really fast, but I would put my money on the CR. Its a really close race between 125's and me on my mildly modded Z400.
what kind of mods you have on your z, because with my blaster I beat 400ex's and Z400's with pipes all the time...If I got my quad running the way it should, they wouldn't even be near me anymore.


Whats the poll say..looks pretty close to me. :)
 

·
Registered
Joined
·
3,937 Posts
alright lets put a little proof on the line real quick...

Here is a blaster that has a drag port and running how it should with a larger carb and race gas I believe, with a toomey pipe, beating on some modified banshees and 400ex's with quite some mods..

You can't tell me that a modified banshee can't beat a 125

http://www.cpcustoms.com/Videos.htm
 

·
Registered
Joined
·
2 Posts
sorry to say it guys, but that cr would get ripped apart by his blaster. I don't know if you saw his video's, but he already beat a cr 125 and stayed right beside a crf250. Also, If I remember right, a crf250 is a hell of a lot faster than a cr 125. Plus, when honda switched the frames on the cr 125 (1998), they switched the engine to the lowest performing 125 cr until 2003 when they switched them again. So, I highly doubt your cr with porting, filter and topend and a crank will beat his blaster. Even with a pipe, you would still get ripped. Sorry to say it, but someone had to.
 

·
Registered
Joined
·
124 Posts
ok factory here you go injoy this now i know you will. ok the bikes i raced were, 2004 honda crf 250, 2001 honda cr 125 procircuit pipe and v force, 2003 stock cr85, kx 85 procircuit pipe and silencer and smaller front sproket, 2004 yz 85 stock, the video below i dint even get a good start
me racen the 250 f yz 85 and cr 85(bad start)

http://www.eengoedidee.nl/videoz/mx/ashbourne_003.avi

me racen my brother and e just gave up lolol

http://www.eengoedidee.nl/videoz/mx/ashbourne_004.avi

same again
http://www.eengoedidee.nl/videoz/mx/ashbourne_005.avi
what you think of that

i bet the 250 twice and most of the time i was even with him
 

·
Registered
Joined
·
1,389 Posts
The best part of winning a race on a blaster is beating someone that hates on them :tup:
 

·
Registered
Joined
·
124 Posts
42F67N said:
The best part of winning a race on a blaster is beating someone that hates on them :tup:
very true :tup: all they ever say is eh i got a bad start becouse i got loads of wheel spin but after 10 races they just shut up and acept :nod:
 

·
Registered
Joined
·
4,234 Posts
who cares which is faster.


your both gay. J/K FE :lol:
 
1 - 20 of 34 Posts
Status
Not open for further replies.
Top