Blue Traxx Forum banner
warrior
1-20 of 95 Results
  1. New Members Introduction
    Hi so just bought a 2000 Yamaha warrior. When I bought it the clutch was hard to pull in and you had to push it back out for it to engage. I change the clutch cable and now it wont release at all. I’m new to working on four wheelers so any help would be appreciated.
  2. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Hi, so I just inherited a 87 warrior with completely chewed up wires(80% chewed up by mice) from my uncle. He said it ran like a champ then he parked it the last 3 years out of the weather. I want to completely swap out the electrical but I'm not sure what I need to get. What parts do I need...
  3. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I have a 1987 Yamaha warrior 350. I got it from a friend, he blew it up. I dropped a new bottom and and top and into it. It seems as though it is stuck in reverse. The reverse selector shaft does not turn enough to go into drive. The reverse light is not on and I have no spark. Wether or not the...
  4. Yamaha YFM350 Raptor/Warrior ('87-Present)
    My father was riding my quad, and stated that it made a loud pop noise. After it made the noise the quad stopped going into gear. The gearing seems to be messed up. Neutral acts like first gear and once you shift into first gear the quad dies. I currently have the quad apart. There appears to be...
  5. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I've recently been given that "bug" for quads. I've never really been interested in them until I rode my friend's built Blaster and 400ex. Now I have to have my own. I was really considering a Warrior because of how cheap they are, their reliability, and the fact they have a reverse gear. I'm...
  6. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I recently acquired a 1988 Yamaha warrior from a friend that was partially taken apart due to it making a knocking noise. I own another warrior so I am somewhat familiar with them and after venturing further into the project I have found that the valve adjustment bolt has backed out and damaged...
  7. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Hello all, I was recently gifted a 1987 Warrior from it's original owner. It's well ridden but runs. as i research this model I keep finding that various parts are 87 only,like the A arms. and ignition. Is there a place that lists the yearly changes in the Warrior model? It would be nice to have...
  8. Yamaha YFM350 Raptor/Warrior ('87-Present)
    My warrior dies when i put it into gear. Has new cylinder , piston , rings ,valves , valve seals , stator , clutch , cdi etc. It died like this before the rebuild , i bought it as a project , but anyway , it dies when i put it into gear , doesn't jump , just dies when i shift into first. With...
  9. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I recently bought a warrior for cheap knowing I would need to replace the cylinder head and a couple other things in the very near future. I rode it for around 15 minutes before it broke down. Just yesterday I had it all fixed up, replaced the cylinder head, cam chain, intake manifold, and a...
  10. Yamaha YFM350 Raptor/Warrior ('87-Present)
    So I fixed my starter clutch problem and I finally got my warrior to start last night. I had to choke it because it's cold out but that's normal. Today it took forever to start the first time and even when the engine was hot I could not get it to start. I took the carb apart and cleaned it and...
  11. Yamaha YFM350 Raptor/Warrior ('87-Present)
    This is my first quad. I was wondering if anyone has suggestions on what brand of oil i should use that is best for cold weather. Thank you
  12. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Hey all I'm new here but I just lost the bolts that hold the starter onto the quad. I was riding and obviously didn't tighten them right and they flew off. Anyways, I'm wondering the dimensions of the two bolts that hold the starter onto the motor. I need the length and and stuff so I can buy a...
  13. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I have a 2000 yamaha warrior. Bought it a month ago ran great then died out.of know where. Lost spark so checked the coil it was fine. Ended up replacing the stator. Got spark back but will only start once after it sits overnight. Will bump start every time tho. Will.not start using the ignition...
  14. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I'm new to this site but I've done lots of looking and still can't find my problem. I'm not that great with electrical systems but heres what I've got. I have an 03 warrior, the motor is an 87, it does have the 03 stator on it, I took it to a shop and they diagnosed it and said the stator was...
  15. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Hey guys its been a while, Im in the middle of a full rebuild and i have the case split. I removed the transmission gear sets for inspection and to oil the bearings. No damage was found and bearings spin well. I put the gear sets and forks back in according to the clymer manual and the detent...
  16. Yamaha YFM350 Raptor/Warrior ('87-Present)
    So my mom told me to get her warrior running again and sell it. Well I got it to start and two seconds later the lower connecting rod bearing went out. So I found a motor, drove 70 miles to get it. Turned out to be a motor for a 1994 banshee. 200 dollars. It ran and turns over so I went ahead...
  17. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Glad i could find a place to help. Having a hard time figuring out what's wrong. Everything runs fine until I get to full throttle then it bogs down and wants to die until I pull the clutch and then it catches. Everything is stock except for a K&N air filter. Haven't had it long, and it didn't...
  18. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Is there anyway to get all the stator questions/answers in one spot? I tried the link in the sticky but just got a "404". Is there another source that shows each year of the Warriors/Raptors wiring colors online? Seems like several people have had this problem. And is there a definitive...
  19. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Hi i am new to this forum and was wondering about an idle problem on my carb. While it is still warming up the engine idle is perfectly normal but as it gets warmer the carbs butterfly valve just kind of sticks all the way open and basically runs full throttle. Does anyone else have this issue...
  20. Yamaha YFM350 Raptor/Warrior ('87-Present)
    Hey guys I just picked up an 87 warrior. Ran for a few days then just stopped. Been in the shop for a week now I need a CDI. Looking for a new or good used CDI. Also if anyone knows where i can get a new one online for a good price let me know, thanks.
1-20 of 95 Results
Top