Search Results for ‘transmission’

I have a 2005 raptor 660 and all of a sudden it is really hard to shift into second. I keeps getting stuck in neutral. If I use my hand and give it a good yank it will go into second and ride fine in that gear, it’s shifting into second that is an issue. This happens whether I use the clutch or...

My father was riding my quad, and stated that it made a loud pop noise. After it made the noise the quad stopped going into gear. The gearing seems to be messed up. Neutral acts like first gear and once you shift into first gear the quad dies. I currently have the quad apart. There appears to be...

hey everyone first post here, I just got a Yamaha Bear Tracker 250 01' from a dude. seemed to be running good besides needing the carb cleaned. ive been tweaking with that and it seems to be running pretty well. but now im starting to notice its skipping a gear sometimes...

Hey guys its been a while, Im in the middle of a full rebuild and i have the case split. I removed the transmission gear sets for inspection and to oil the bearings. No damage was found and bearings spin well. I put the gear sets and forks back in according to the clymer manual and the detent...

Hello everyone, I am new to the Fourms here and I really need some help with my bike. I was recently riding and turned my bike off about 2 hours into the ride for a break. After the break I started my bike up but as soon as I went to take off the bike acted like it was under load and stalled...

Ok, so I just "finished" rebuilding a 2000 blaster. Had to replace entire trans due to 1st gear being in 4 pieces. Now I can't get it to engage gears. Trans went in smooth with full operation even after cases were resealed and all gears installed. Clutch issue? Shift drum in wrong? (forks are...

I recently bought a 1990 Yamaha Big Bear 4x4 350 for a good price, But it needs it's share of work. A few problems I have ran into. I cleaned the carb, and lubed the cables.. But for some reason the ATV wants to idle high, I've cleaned all the jets, (Didn't take any out) and I've backed all the...

Hey everyone I'm new here and am having some problems with my quad. I just redid all this cosmetic work on a 2000 350 warrior. New plastics, lights, pipe, seat, grab bar, etc. Also put on a new clutch cover and shift lever. It ran great and one day went out to start it and once it ran for...

I just purchased a 1996 Kodiak 400 4X4. Knowing little about these (I have a motorcycle background), I believe I may have a clutch issue. First, this one has the 5 speed manual shift (clutchless) tranny. When you accelerate from a stop, the engine winds up for a few seconds, then...

i have an 03 banshee with stock clutches and for some reason my 6th gear went out i can wind it out 1st thourgh 5th but when i hit 6th it sounds like its in neutral and sometimes i can wind 5th and and let it coast for a sec and shift up and it will go into 6th gear but the minute i let off the...