Blue Traxx Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Yamaha YFM350 Raptor/Warrior ('87-Present)
    I have a 2005 350 Raptor. (When I purchased it in 2006, it had 21 hours. Now it has 29.5. I don't ride) The engine will crank but it will not run. The two times I have wanted to use it I have had to take to a repair place. Both times for the same thing, I was told the fuel had gummed up and...
  2. Yamaha YFZ350 Banshee (1987-Present)
    So im new to bansheeeees!!Its also my first build but my question is about jetting! i just got Toomeys T5s and K&N dual filters and as far as airbox goes that is still to be determined by what is best? getting cylinders bored out to 64.50 and everything else is stock!So what would be my best...
  3. Yamaha YFM660R Raptor (2001-2005)
    I plan on breaking down my stock 01 660 enough to get the carburetor out, clean it up and put the correct jets in it. 1.I've read that the wrong jets are in this year from stock. True? if so what do some of you recommend? 2. Anything else I should do to increase performance or just general...
  4. Yamaha YFM350 Raptor/Warrior ('87-Present)
    My warrior has hasnt been fired up for almost two years. i could clean it up but as long as it's apart i just as well rebuild. Any suggestions on a kit that will make it a little faster and run better?
  5. Yamaha YFZ450/450R (2004-Present)
    Ok im putting new rings on my piston. Since i have the top end apart i was thinking of doing the cam mod. Should I do the cam mod? if i do the cam mod will i need to do some carb work? If i did carb work what should i do b/c i have a trinity drag pipe and i was thinking about taking the airbox...
1-5 of 5 Results
Top