Search Results for ‘idle’

Hi Folks My raptor seems to be dying at idle after being ridden very hard :s96: -under normal riding conditions it idles fine without any problems. After dying it takes a few turns of the starter for the motor to run. My initial thoughts was that it was overheating but when checking the rad-fan...

Hi I'm new to the site I've been looking through here but I can't really find answers to my exact problems >.< well first off the carb overflow tubes were leaking gas like crazy I figured that was just the float so I took them apart and cleaned them and that problem was fixed. But I still have...

After searching for hours on several different sites I finally just decided to post my problem/attempts at fixing and see if anyone else has experienced this.. Quad idles rough (will die if idle not set very high) and anywhere off idle it misses/stutters every 3rd to 20th combustion stroke...

I have a Kodiak 400 that idles fine but bogs or dies at any throttle. I have - Drained and replaced gasoline. Replaced fuel valve due to the screens being cracked. I have put all new jets in the carb. I have cleaned the carb 3 times, the last time i soaked and blew it out with an air tank. I...

I just purchased a 2005 raptor 660r. It came with a curtis sparks x6 full exhaust and a pro flow air filter. The jets are 25 pilots and 167.5L/177.5R mains. Now the problem is that when I start it, the idle seems way too high. My headers then start to glow within seconds and I get constant...

So I needed to change the throttle cable to my 98 Blaster, and the new twist throttle comes with a cap and wants you to bypass the TORS unit. (The adjuster at the end of the cable is too small to fit in the TORS unit so I have to go straight into the carburetor.) Do I have to buy a TORS...

hello, i have just recently purchased an '02 warrior and between me and my friend have been able to get it to idle perfectley but when you give it gas there is absoloutley not throttle response and it seems to bog down and if u give it full throttle will die, looking for any suggestions...