Blue Traxx Forum banner

gears

  1. Bear Tracker 250 skipping a gear????

    Other Models/Brands
    hey everyone first post here, I just got a Yamaha Bear Tracker 250 01' from a dude. seemed to be running good besides needing the carb cleaned. ive been tweaking with that and it seems to be running pretty well. but now im starting to notice its skipping a gear sometimes...
  2. Case/generator cover not aligning properly

    Yamaha YFM660R Raptor (2001-2005)
    It's the small cover that goes over the starter gears. For some odd reason I just cant get the cover to go flush with the main case. Top part of cover is flush but bottom half sticks out about a 1/8" inch. Any idea what is holding the cover up? I know it is not the gears because I tried putting...
  3. Gears Slipping at High Throttle

    Yamaha YFM350 Raptor/Warrior ('87-Present)
    My warrior seems to be slipping in all gears mainly 2nd through 6th when i really have the throttle open. But then if i ease it into the the gear its fine.. Is it the clutch/clutch plates going bad?
  4. My running blaster wont engage gears....?

    Yamaha YFS200 Blaster ('88-Present)
    Ok, so I just "finished" rebuilding a 2000 blaster. Had to replace entire trans due to 1st gear being in 4 pieces. Now I can't get it to engage gears. Trans went in smooth with full operation even after cases were resealed and all gears installed. Clutch issue? Shift drum in wrong? (forks are...
  5. Need Help With My 87 Warrior

    Yamaha YFM350 Raptor/Warrior ('87-Present)
    Well, Just bought a 87 warrior for 400$ in somewhat good condition doesn't smoke runs nice and everything. My problem... When i shift into a gear it will go in nicely but coming out, if im not moving is like no other, it really wont i always turn it off and have to fiddle with it. But the...
Top